I‘m continuing my series on gift card holders! This one is a quick and simple one using Designer Series Paper. You can make as many as 3 at a time from a single sheet of 12" x 12" paper, or you can just cut out one. For these, I've used the beautiful Ever Eden Designer Series Paper that is only available till January 3rd, or while supplies last.
If your paper has a directional design, place it on the inside of the gift card holder and take note of how to orient the paper. This project was inspired by Krystal Roberts.
Measurements to make 3 at one time:
-Ever Eden Designer Series Paper
12” (W) x 9” (H), scored at 2", 3-1/4", 4-1/2", and 7-1/4" along the short side, as measured from the *bottom* of the paper. After scoring, cut the paper at 4" and 8" along the long side.
THREE 1" (W) x 6-1/2" (H), scored at 1-1/2" and 4-1-2" along the long side
-Basic White cardstock (optional)
3-1/2" (W) x 2-3/8" (H)
To make just 1 gift card holder,
4” (W) x 9” (H), scored at 2", 3-1/4", 4-1/2", and 7-1/4" along the long side, as measured from the *bottom* of the paper
1" (W) x 6-1/2" (H), scored at 1-1/2" and 4-1-2" along the long side
-Basic White cardstock (optional)
3-1/2" (W) x 2-3/8" (H)
Shoppable Supply List:
Ever Eden | Quick DSP Gift Card Holder
Commentaires